Wetswinger Go Deep Forum Supporter Nov 18, 2022 #1 How do you go about thinning rod finish epoxy? I would like to be able to apply a thinner first coat if possible without it clouding up.. Thanks..
How do you go about thinning rod finish epoxy? I would like to be able to apply a thinner first coat if possible without it clouding up.. Thanks..
Scudley Do Right Life of the Party Nov 18, 2022 #2 I've read about people using iso alcohol. I would do a test run to find the right amount.
Rob Allen Life of the Party Nov 18, 2022 #3 Thin first coat trim your brush at an angle and use less finish heat with an alcohol lamp to flatten.
Thin first coat trim your brush at an angle and use less finish heat with an alcohol lamp to flatten.
nomlasder Smolt Nov 18, 2022 #4 Use denatured alcohol, not rubbing. Too much will make the finish not harden properly and turn rubbery.
Use denatured alcohol, not rubbing. Too much will make the finish not harden properly and turn rubbery.
M MELinOre Steelhead Nov 19, 2022 #5 Flex Coat Lite https://flexcoat.com/shop/finishes-and-adhesives/rod-finish-lite
Wayne Kohan Life of the Party Nov 19, 2022 #6 A drop or two of acetone thins it nicely. I have done that to the first epoxy application for transparent wrap.
A drop or two of acetone thins it nicely. I have done that to the first epoxy application for transparent wrap.