Poor Man's 8ft Hopper

Cliff

Cliff

Steelhead
Looking for advice. I bought this little plastic boat several years ago as an inexpensive flyfishing pram, but Ive only used it a few times over the years. Now that I'm retired I'm thinking about using it more often. The thing is "naked" except for the oars. The seat is hard and hurts my old flat butt. If you were to fish this boat off, without spending an arm and a leg, how would you do it? A swivel, padded seat? Anchors and pulleys fore and aft? Scotty rod holders? Any advice would be appreciated. Thank you.
Cliff
 

Attachments

  • IMGP0440-XL.jpg
    IMGP0440-XL.jpg
    470.3 KB · Views: 19
  • IMGP0441-XL.jpg
    IMGP0441-XL.jpg
    325.6 KB · Views: 18
  • IMGP0442-XL.jpg
    IMGP0442-XL.jpg
    627.3 KB · Views: 22
  • IMGP0443-XL.jpg
    IMGP0443-XL.jpg
    450.2 KB · Views: 19
I’d add some type of seat with a back. You’ll appreciate being able to lean back.
Also note that seat height is something to look at as to how the oars will work while rowing.
SF
 
I really like my Scotty accessories on my small boat: A couple rod holders, one with an integrated cup holder, and an anchor pulley.
 
What @Stonedfish says about seat height (in relation to your oars/oarlocks) - my pram is 8' long, the seat is a padded Fish on seat mounted on a swivel. I can't tell from your pictures where the oarlocks are in relation to where you'd fasten a seat. I use Scotty mounts for my anchors (centered at the bow and port side on the stern). As you can see on the bow, the Scotty mount is on the outside of the bow (same for the stern). I've never figured out a good location for rod holders so, living dangerously, I hang the reel on the bow side of the wood bench my seat is mounted to when "trolling" (I have "V" notched rod holders that fit in hand grips on the outside of the stern), otherwise it's in my hand unless I'm desperate enough to "2-pole" fish.

1785813745666.jpeg


Have fun setting it up!!
 
Agree with SF. You have to be cognizant of being able to row with the seat height, which may be an issue in that boat.

You can put Scotty anchor pulls in the bow and stern and take a look at the Berkeley quick release rod holders.
 
They make extension oar-locks to raise your oars. If you get a rotating seat, recommend, you’ll be sitting higher and will need to get the oars up above your thighs. The oars angle will change the higher up they are..two anchors? yes..A big bow one to set you in and a smaller stern one to keep the rear from swinging..Rod holders? Meh..you’ll figure something out..keep it simple at first, and then you can customize it as you gain experience..
 
Last edited:
You must log in or register to reply here.
Back
Top