Very nice and thorough report, Mike
I did note that when using potassium permanganate, it does not stain any enamel left on the cane.
Thanks for helping me understand the splicing process.
After gluing up the spliced splines, I ran them through the Baginski mill to clean up the edges and size them for the planning form. The one thing that I noticed immediately, is that without the nodes, the splines planed like butter. No stalls or chips.
I did stagger the splices but primarily to avoid a potential “picket fence” look. After glue-up though, the splices on the rod are difficult to spot without magnification.
Since this was my first spliced rod – a Bokstrom 8’3” Cutthroat taper – I decided to run an experiment.
I hollowed the rod before glue-up and added intermediate wraps to one of the tip sections. The intermediates consist of 5-wraps of #100 silk evenly spaced between the guides; 35 intermediates in total. The wraps on both tips received two coats of varnish and then the rod sections received two dips in the varnish tank.
The tips weighed exactly the same before wrapping: 18.4 grams which includes the male ferrule and tip top. It took 306.3 grams for both tips to bend to a 30” arc from horizontal.
In the end, the tip with the intermediate wraps weighed only 0.2 grams more than the one with just guide wraps. I honestly expected it to be heavier. It was also 6% stiffer – taking nearly 325 grams to bend in the same arc, which was both a surprise and quite apparent.
I haven’t had a chance to cast the rod, but I am curious how all 72 splices in butt and tip sections hold up.
Steve Foisie