3M 4000

M_D

Bringin' the Skunk
Forum Supporter
Several months ago I bought what appeared to be a new pair of waders at my local Goodwill.

The first use showed they must have been factory rejects or a warranty return cuz they had serious leaks along the seams

IMG_0719.jpeg
IMG_0718.jpeg

I tossed them in a back corner until I decided what to do with them.

It’s now kinda in between seasons in my area, so I decided to mess around with the waders.

I was gonna go the re-tape route but after reading about OldKid’s repair failure, I dug a little deeper.

A while back somebody shared a link to a YouTube duck hunting channel

IMG_0722.jpeg

One of the sessions dealt with wader repair and all the products the guy had tried. He liked 3M 4200 the best but my local shop was outa stock so after checking 3M’s comparison guide

IMG_0721.jpeg

I went with the 4000….

more to follow
 
A 3oz tube was tad cheaper than a similar amount of Aquaseal

IMG_0720.jpeg

and it was just as sloppy to work with. If you’ve ever used 3M’s 5200…it’s pretty much the same…so wear exam gloves.

The 3 oz tube covered all leg seams below the waist….barely

IMG_0684.jpeg

this one just shows a close up of the crotch area repair. As you can see I put the stuff on fairly thick.

IMG_0685.jpeg

I considered working a fabric tape into the goop before it cured but after covering one seam, it seamed unnecessary ( see what I did there? 🙃 )

It took a couple days to complete in order to cure one seam before repositioning the waders to goop up another but not a big deal.

Yesterday I took them to the river for a couple hours. I was knee to waist deep for easily 30 minutes a time and had no problems. Plus I probably walked 1.5 miles in the waders.

Yes it’s only one outing but far so good. If I remember, I’ll post updates in the future

carry on
 
Back
Top