Recent content by Haggis57

I use the same 14oz retractor to keep my Folstaf at the hip in the same position.

Even more curious, Outcast apparently marketed a version of the Scout with a welded rear IGS pad in Korea for a while.

Thanks for the info. I wondered if the glue on mount would work - I never thought of following up with Outcast. Pictures of the completed mount would be appreciated. Check out this previous thread from 2024 on installing a trolling motor on a Stealth Pro. Lots of good ideas on motor control...

I'd be interested in know what Outcast recommended for a motor mount. I made a PVC one that cam straps on without any mods to the boat. It works fine with a Minn Kota C30 but is probably on the heavy side after the addition of the launching wheels. I agree with recommendations above to try a...

I think you're right that stern first is probably more aerodynamic, considering the seat bottom up to the stern is pretty much flush with the bottom of the two pontoons. I did try it that way when I first got the boat and had a friend follow me with both setups. With the stern first setup...

My Fish Cat Scout is secure enough on Thule roof racks on my Honda CR-V at highway speeds but I really take a hit on gas mileage. I'll put to boat on the racks for shorter 30 - 40 minute trips between lakes but have the boat deflated and inside for anything longer.

I also upgraded from a Fishin Buddy 120 to the Garmin Striker 4 on my Fish Cat Scout. Same comments as above re: appreciating the updated technology - and occasionally missing the side scan feature! I used a Strap-on Mount from fishfindermounts.com for the screen and transducer. They make...

A lighter alternative for the longer rod holder to use thin walled (2mm - 1/16" wall) PVC central vac piping. The 60inch rod holders I made (shown below) for the back seat of my Honda Ridgeline were by Broan-NuTone, but the big box stores in Calgary carry IPEX now. The thinner wall is easier...

I found this thread useful when I was looking for a heat "supplement last fall. Based on that info, I ended up getting a pair of these Ocoopa warmers. My plan is to use them in my thigh pockets for early/late stillwater fishing as well as wading. They put out a lot heat, even on the low...

As @clarkman mentioned, the 10" depth along with the flat bottom on the Frabill Trout gives a lot more control over larger fish.

Bob, I wouldn't hesitate to email Outcast customer service with your questions. I've bought 3 used Fish Cat pontoons over the last 10 years and Outcast has answered questions I had on each of the boats. I've always received replies in less than 1 working day - they really have their customer...

Depending on the spacing of those attachment points, a motor mount like this could work. The last picture in the Amazon ad shows dimensions.

I picked up an unused Simms 2018 Vertical Mesh vest (discontinued in 2021 I think) this Spring and it is working out well so far. At 68, I've switched to pant waders and limit my wading to mid-thigh as well. When I moved to the pant waders, I started to carry more of the heavier bulky items on...

I really like my older (15yr plus) Columbia PGF Wading Jacket/shell which the traditional waist length. It weighs 1 lb-2 oz and conveniently fits into a much older REI-style 1 liter water bottle holder. I usually wear pant waders with a water bottle, net and wading staff on my waist belt to...

I'll second the recommendation for Soundcore. I've been using their Q20+ over ear headphones for 3 years. Let's a cranky old guy get an afternoon nap even with infill construction going on a couple of doors down. I usually use Pixel Buds when listening to music.